The Shop > Metal Stuff
Casting Brass
doubleboost:
It may have been a lot cheaper to buy a lump of 6 inch brass bar , but not nearly as much fun.
I am now looking to cast cylinder covers and valve chest covers.
CrewCab:
--- Quote from: doubleboost on January 21, 2010, 07:07:49 PM ---It may have been a lot cheaper to buy a lump of 6 inch brass bar , but not nearly as much fun.
--- End quote ---
Exactly ............ Well done lads :bow:
CC
doubleboost:
Cylinder covers
We are starting to enjoy melting metal
Brass_Machine:
Nice job! Want to try that sooo bad. One day!
Eric
rleete:
Me, too. The one thing that is stopping me, is that I already have so many projects. Getting into yet another would mean they all suffer even more time deficit.
Nice finished part. I have one quibble, though. You spent all that time on the casting, and yet machined it all. It looks too good - no evidence at all of the work that went into making the casting. I'd say you should leave the outside diameter in an as-cast state. I know I'd want to, so I could point to it and say, "I made that from scratch".
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version