Gallery, Projects and General > How do I??
Soft MT2 blank
John Rudd:
--- Quote from: geroli on November 21, 2009, 02:29:15 PM ---The mt2 blank bored (the finish is not very good) but as Stew suggested it cut with the TC tip.
Then it was impossible to drill so I made a small oven with 5 fire bricks and heat it up to soft oranje and left it in the oven to cool over as long as possible. Thanks John Rudd .
Gerhard
--- End quote ---
Glad to hear you resolved your problems... :thumbup:
Bluechip:
Bit late to the party but ....
http://www.axminster.co.uk/product.asp?pf_id=21342&name=groz&user_search=1&sfile=1&jump=44
I've used these on several occasions, They are readily machinable .. with hss or tipped tooling ..
Dave BC
John Rudd:
ARC also do them and with differing threads if needed... :D
http://www.arceurotrade.co.uk/Catalogue/Blank-End-Arbors
Gerhard Olivier:
That one is the 40mm metric one from ARC but it was no fun working with it but the end result came out fine.
I didn't know Axminster sold them - I have always had very good service from Axminster so worth remembering.
Thanks
Gerhard
Navigation
[0] Message Index
[*] Previous page
Go to full version