Gallery, Projects and General > How to's

Fixing a Moore & Wright level

<< < (7/7)

PekkaNF:
Thank you much Matthew,

I was thinkking that silicon. I presume it is stable enough too? I started to think thermal and moisture properties of it and then started to think that it might not be as big problem as it intilaly looks if there is constant "ring" around the tube and reasonnably symmetrical to both ends. Sagging and thermal expanison shoud be to some extent self canceling.

You probably have a cunning plan?

I'm thinkking of using silicon as sealant/thin O-ring and check if it works. If it does not, then POP it.

mattinker:
Pekka,


--- Quote from: PekkaNF on September 20, 2018, 07:32:43 AM ---Thank you much Matthew,

I was thinkking that silicon. I presume it is stable enough too? I started to think thermal and moisture properties of it and then started to think that it might not be as big problem as it intilaly looks if there is constant "ring" around the tube and reasonnably symmetrical to both ends. Sagging and thermal expanison shoud be to some extent self canceling.

You probably have a cunning plan? Not yet, I'm still thinking about how I'm going to mount the tubes holding the vials.

I'm thinkking of using silicon as sealant/thin O-ring and check if it works. If it does not, then POP it. This sounds like the right track to me, keeping the thickness of the silicon minimal with something like short thin card tubes to hold thigs in place while the silicone cures.

--- End quote ---

Regards, Matthew

Navigation

[0] Message Index

[*] Previous page

Go to full version