Gallery, Projects and General > Project Logs
Colin Thorne's - Skeleton Timepiece
Stilldrillin:
Chris,
Take a light pass, (make a witness mark), in your chosen cutting position......
Rotate blank/ indexer 180dgrs.
Don`t disturb Z. Move cutter in Y axis, to align with the mark you made, in it`s new position.
Observe cutter position relative to existing mark.
Adjust in Z axis until this process produces only 1 witness mark, in both 180dgr positions of the indexer........ :thumbup:
MUCH easier to do, than to explain! :scratch:
David D
raynerd:
Makes perfect sense now, cheers Dave. That is a great idea. Basically, if it isn`t centre it`ll make two marks instead of one - got ya! :ddb: :thumbup: :thumbup:
Chris
Stilldrillin:
--- Quote from: craynerd on December 05, 2009, 12:14:30 PM ---Makes perfect sense now, cheers Dave. That is a great idea. Basically, if it isn`t centre it`ll make two marks instead of one - got ya! :ddb: :thumbup: :thumbup:
Chris
--- End quote ---
Thas right! :thumbup:
raynerd:
A bit of an update - not much but the frame is now cut and this is the first assembly. I need to square the bottoms of the frames. Camera phone so not the best quality:
sbwhart:
Looking good Chris
Have fun
Stew
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version