| Gallery, Projects and General > Project Logs |
| Colin Thorne's - Skeleton Timepiece |
| << < (10/13) > >> |
| Stilldrillin:
Chris, Take a light pass, (make a witness mark), in your chosen cutting position...... Rotate blank/ indexer 180dgrs. Don`t disturb Z. Move cutter in Y axis, to align with the mark you made, in it`s new position. Observe cutter position relative to existing mark. Adjust in Z axis until this process produces only 1 witness mark, in both 180dgr positions of the indexer........ :thumbup: MUCH easier to do, than to explain! :scratch: David D |
| raynerd:
Makes perfect sense now, cheers Dave. That is a great idea. Basically, if it isn`t centre it`ll make two marks instead of one - got ya! :ddb: :thumbup: :thumbup: Chris |
| Stilldrillin:
--- Quote from: craynerd on December 05, 2009, 12:14:30 PM ---Makes perfect sense now, cheers Dave. That is a great idea. Basically, if it isn`t centre it`ll make two marks instead of one - got ya! :ddb: :thumbup: :thumbup: Chris --- End quote --- Thas right! :thumbup: |
| raynerd:
A bit of an update - not much but the frame is now cut and this is the first assembly. I need to square the bottoms of the frames. Camera phone so not the best quality: |
| sbwhart:
Looking good Chris Have fun Stew |
| Navigation |
| Message Index |
| Next page |
| Previous page |