Gallery, Projects and General > Project Logs

QCTP

(1/2) > >>

ozzie46:

  I made a QCTP for my Grizzly 10 X 22.

 Here are some pics.

 

 

 

 


I'm really liking this tool. I used the almost completed tool to knurl some stock and part off the height setting knobs/nuts.

 I will need to make one for my 7 X  now.

  Ron

andyf:
Nice job, Ron.  :thumbup: I bought a QCTP "block" + 2 toolholders for my 7x at a show here in the UK. The toolholder population is now 6, and will increase even further once I've picked up some more 1 x 2.5" bar. But the temptation to make one for every tool I own must be resisted, or I'll never do anything else. Eight or n2ine will cover all the usual  tools, plus another reserved for those only used once in a while.

Andy

ozzie46:

 I've got 7 holders made. Still need a few more, but will make them in the future.

  Ron

Bernd:
Nice work Ron. I'm going to need some for my 9 X 19 Grizzly if I ever get it back together again.

Were did you find the plans?

Bernd

ozzie46:
  I found them here,

http://homepage3.nifty.com/amigos/qctp/qctp-e.htm

  There are some missing dimensions but they can be worked out. I didn't follow them faithfully, but I stuck pretty close.

  You might want to see this post on HMEM. Go to post #17. There is a pdf put up by "Doc". I was pretty well along on mine or I might have made this one.
 

   http://www.homemodelenginemachinist.com/index.php?topic=6471.15

  
   Ron

Navigation

[0] Message Index

[#] Next page