Gallery, Projects and General > Project Logs

Tailstock tap and die holders.

(1/3) > >>

Gerhard Olivier:
This is a project that really is far down on the tuit list but the lathe project has changed the priorities a bit.


I needed some 3/16 BSW bolts with partially countersunk slot heads.?????

So some ali bar stock 1 1/4 I think



This cut consentric and faced of drilled for the revolving centre  and knurled (I still want to mod that knurler and make 2 more) 




A bit of profiling to make it look a bit friendlier.
After boring the resses for the die a test fit nice and snug.




Then I drilled and bored and reamed the centre hole to a depth that would be trough after parting.





Then I parted and faced the other side with some leather to protect the knurlling




And the semi final part





The first 3/16 BSW bolt




Note that there is only one grub screw that is because this is going to be a die holder-holder not a die holder the plan is to make small holders that fit into this part for all the small taps and dies (they will all be set up already for swopping over.
The 1 inch dies will get a holder holder that has 4 handles at 90 deg etc.


Gerhard

RobWilson:
Very nice Gerhard

great knurling job ,very clean  :thumbup:  ,,,, somthing i have to get round to making


Regards Rob

bogstandard:
Gerhard,

Your work is improving all the time.

Very nice stuff you have done there.

John

Gerhard Olivier:
Bogs and Rob thanks for kind comments

Gerhard

sbwhart:
Good work Gerhard

Well made tools pay you back a 1000 times over:- you learn when you make them, and after they improve your work every time you use them.

Have fun

Stew

Navigation

[0] Message Index

[#] Next page