Gallery, Projects and General > How to's

Drilling copper

<< < (2/2)

Bluechip:
mcr

Holes in copper what. Bar or sheet? Size?

I've poked a good few holes in alum. sheet in my time, not too dissimilar from copper.

Once I saw large (30mm) ish holes put in copper anodes with a spade drill using milk as Bernd said. If it's sheet, use a chassis punch or holesaw.
If they are small holes 1/8 - 1/2" ish you might try a carpenters  lip & spur drill. Cheapish, the lips will scribe the outer, and the spike in the middle will locate.
I have used 'em on ally sheet to stop the '?-agon' effect. Useless for deep holes I suspect. Never tried that.

Also need a backing material to stop chewing up on breakthrough.

http://www.axminster.co.uk/product-Axminster-Lip-and-Spur-Bit-20964.htm

Dave BC

bogstandard:
MCR,

As previously stated, cows milk is a good cutting lubricant, and try to get the full cream variety. It is something in the fat content that does the magic deed.
 
Tallow is the correct lube, but they are very difficult to catch at this time of year. Their legs fall off in the summer months, so they can't land until they grow back again, which is usually around Christmas time. Processed lard (shortening) is a good substitute.

I have had great success with both bullet tipped twist drills for the smaller holes, and Aldi 'special buy' cone drills for the larger stuff. Trepanning works for really big stuff.

You need that guiding centre to stop it jumping about and making those 'triangular' shaped holes.


Bogs

malcolmt:

Hi Bog's
I liked this : -     

"Tallow is the correct lube, but they are very difficult to catch at this time of year. Their legs fall off in the summer months, so they can't land until they grow back again, which is usually around Christmas time"

I have found that living in the country, it is acceptable to shoot your own Tallow and it is regularly available from dodgy looking chaps even out of season.

 :D  :D  :D  :D  :D  :D  :D  :D  :D

Kind regards

Malcolm

bogstandard:
Hi Malcolm,

Long time no see or hear. :wave: :wave:

We all need a bit of humour now and again, even us old grumpy pharts. :D


Bogs

usn ret:
For thin sheet of just about anything "Step Drills" mfg by Irwin produce adequate results. Sizes range 1/8 to 1 1/4". The drills are sold in sets of 3 ranges ie. 1/8 to 1/2" , 3/16 to 3/4" and 3/8 to 1 1/4".  I have used the to drill holes in thin sheets of alum, steel and stainless with acceptable results. On the east side of the pond they may be called cone drills or something else a bit odd. If you Google "step drills" it will produce sources for aforementioned bit..  The Irwin site produces the best results "Unibit step drills.  "Time for :coffee: :coffee:
Cliff

Navigation

[0] Message Index

[*] Previous page