Home Base > Introductions

New member:

(1/5) > >>

RDL:
This is actually my third post - couldn't even get the site introduction right.

I am new to the MadModder and found it by following a link to a picture of a Power Hacksaw project I had posted on another website.  Since it was a Shaper related project I was hoping to see a Shaper dedicated forum.  Alas, that was not the case but perhaps that could happen one day.  Perhaps the Admin will look favourably on the request.

Raymond

sbwhart:
Welcome aboard the cube Raymond  :borg:

We're into all sorts of machines and project on her so we'd be happy with your shaper adventures but you must show lots of pics  :worthless:

Have you any other machine tools ?.

Have fun

Stew

CrewCab:

--- Quote from: RDL on September 24, 2009, 02:48:47 PM ---This is actually my third post - couldn't even get the site introduction right. 
--- End quote ---

No worries Raymond  :thumbup: welcome aboard, just join in and have fun

CC

RDL:

--- Quote from: sbwhart on September 24, 2009, 02:53:05 PM ---Welcome aboard the cube Raymond  :borg:

We're into all sorts of machines and project on her so we'd be happy with your shaper adventures but you must show lots of pics  :worthless:
...
Stew

--- End quote ---

Here is a picture after I took it off a pallet without a crane or hoist.  Yes I have a small lathe and mill after all I need them to make tools for the Elliott Invicta Major shaper.



Raymond

tinkerer:
Welcome Raymond. :nrocks: I have no idea what a shaper does :scratch: maybe fenders for NASCAR, no that would be an english roll. I'll look it up.

Navigation

[0] Message Index

[#] Next page