| Home Base > Introductions |
| New member: |
| (1/5) > >> |
| RDL:
This is actually my third post - couldn't even get the site introduction right. I am new to the MadModder and found it by following a link to a picture of a Power Hacksaw project I had posted on another website. Since it was a Shaper related project I was hoping to see a Shaper dedicated forum. Alas, that was not the case but perhaps that could happen one day. Perhaps the Admin will look favourably on the request. Raymond |
| sbwhart:
Welcome aboard the cube Raymond :borg: We're into all sorts of machines and project on her so we'd be happy with your shaper adventures but you must show lots of pics :worthless: Have you any other machine tools ?. Have fun Stew |
| CrewCab:
--- Quote from: RDL on September 24, 2009, 02:48:47 PM ---This is actually my third post - couldn't even get the site introduction right. --- End quote --- No worries Raymond :thumbup: welcome aboard, just join in and have fun CC |
| RDL:
--- Quote from: sbwhart on September 24, 2009, 02:53:05 PM ---Welcome aboard the cube Raymond :borg: We're into all sorts of machines and project on her so we'd be happy with your shaper adventures but you must show lots of pics :worthless: ... Stew --- End quote --- Here is a picture after I took it off a pallet without a crane or hoist. Yes I have a small lathe and mill after all I need them to make tools for the Elliott Invicta Major shaper. Raymond |
| tinkerer:
Welcome Raymond. :nrocks: I have no idea what a shaper does :scratch: maybe fenders for NASCAR, no that would be an english roll. I'll look it up. |
| Navigation |
| Message Index |
| Next page |