Gallery, Projects and General > Project Logs

Machine Vice

<< < (5/6) > >>

sorveltaja:
Is there some kind of T-piece, where tightening screw goes?

I have seen that kind of vices only on pictures.

Gerhard Olivier:
Is there some kind of T-piece, where tightening screw goes?

There is a plan on

http://www.projectsinmetal.com/free-metalworking-project-plans-toolmakers-screwless-vise-mill/

Hope this works / helps

Gerhard

PhiberOptix:

--- Quote from: sorveltaja on September 12, 2009, 01:44:09 PM ---Is there some kind of T-piece, where tightening screw goes?

I have seen that kind of vices only on pictures.

--- End quote ---

yes there is a 'T' piece






All I used was a slice of round stock drilled and taped to match the locking cap head
and an off center hole thu the side for the locking pin (in this case a 1mm wire)
also there is a slot milled in the underside of the jaw to locate the slice into
to stop it rotating whilst putting the pin thu

There are plans for this vice but i did not use any

Hope this helps

The same method was used in her bigger sister

sorveltaja:
Thanks for the replies! They helped me to understand the mechanism :beer:.

arnoldb:
Good going Andy  :clap: :clap:
And to think you groaned about Tiny being small  :lol: - come to think of it, have you found a compressor yet ?

 :beer: Arnold

Navigation

[0] Message Index

[#] Next page

[*] Previous page