| Gallery, Projects and General > Project Logs |
| Machine Vice |
| << < (5/6) > >> |
| sorveltaja:
Is there some kind of T-piece, where tightening screw goes? I have seen that kind of vices only on pictures. |
| Gerhard Olivier:
Is there some kind of T-piece, where tightening screw goes? There is a plan on http://www.projectsinmetal.com/free-metalworking-project-plans-toolmakers-screwless-vise-mill/ Hope this works / helps Gerhard |
| PhiberOptix:
--- Quote from: sorveltaja on September 12, 2009, 01:44:09 PM ---Is there some kind of T-piece, where tightening screw goes? I have seen that kind of vices only on pictures. --- End quote --- yes there is a 'T' piece All I used was a slice of round stock drilled and taped to match the locking cap head and an off center hole thu the side for the locking pin (in this case a 1mm wire) also there is a slot milled in the underside of the jaw to locate the slice into to stop it rotating whilst putting the pin thu There are plans for this vice but i did not use any Hope this helps The same method was used in her bigger sister |
| sorveltaja:
Thanks for the replies! They helped me to understand the mechanism :beer:. |
| arnoldb:
Good going Andy :clap: :clap: And to think you groaned about Tiny being small :lol: - come to think of it, have you found a compressor yet ? :beer: Arnold |
| Navigation |
| Message Index |
| Next page |
| Previous page |