Gallery, Projects and General > Project Logs
Machine Vice
NickG:
Just wondering, how are you going to clamp it down to the table?
sorveltaja:
Is there spesific english language term for that kind of machine vice? I'm willing to build one(two, maybe three) small(er) versions for special purposes.
PhiberOptix:
--- Quote from: NickG on September 10, 2009, 04:13:19 PM ---Just wondering, how are you going to clamp it down to the table?
--- End quote ---
I'm not lol, its going sideways in the vice it was made in
but...
I guess you can put longer pins thu the side holes and clamp down on them
or mill clamping slots in the ends & sides
I have seen blocks with pegs in the side just for clamping these down
but mines going in another vice so you adapt/mod your to you needs
regards
Andy
PhiberOptix:
--- Quote from: sorveltaja on September 10, 2009, 04:43:04 PM ---Is there spesific english language term for that kind of machine vice? I'm willing to build one(two, maybe three) small(er) versions for special purposes.
--- End quote ---
I have only ever know them as a machinist's vice I am unaware of any specific name
I'm sure it probably has one I just dont know it, maybe someone could enlighten us
Andy
bogstandard:
First ones on here
http://www.arceurotrade.co.uk/Catalogue/Workholding/Machine-Vices
I use a 1" one all the time for holding small stuff in my larger vices.
Bogs
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version