Well, it's 00:56 and just finished off the drawings for the Rocking Engine, they're not great but good enough for what I need. Some bits might be under specified, but if they are, they are obvious bits to me! The guys at work would tear them apart but it's not work, it's a hobby so not going to worry too much about that!
I've just realised I have no means of printing the drawings out ... printer cartridges ran out a long time ago!

The garage is just about sorted now, just need to bolt down grinder, drill, mill and vice and tidy up a bit more. I might be able to make a start on this tomorrow but if not, certainly during the week. I will be able to save them as a different format and print at work if I can't get cartridges.
Quite looking forward to this now!
Nick

so example drawing attached.