The Shop > Finishing |
Rust Removal |
<< < (10/12) > >> |
bogstandard:
Darren, I hope you aren't going to be painting your floor with the same paint. I can imagine you walking round and bumping into all the camouflaged machinery. :lol: Bogs |
Darren:
Very good John, very good.... :clap: it'd be like one of those modern white rooms........ :doh: Talking of which, it almost got pained white, the paint is here.....I never was very good a making decisions....I still might yet....... :scratch: Stew, the nicest thing about all this is just how little effort it all takes. The old way was such a pain most tools just got a cover up inc chips, chunks, rust an' all. Add the fact that the whole process inc paint will cost about £10 or less, then it's a no brainer.... I painted my lathe with floor paint, comes in quite a few colours, it's tough (just think of the punishment it gets on the floor) It paints easily. I just brush it on and then run a small roller over it to give a nice finish. Lastly you don't need a hundred brushes or rollers as they keep/wash in white spirit till next time they are needed. Shall I paint it white........ :bang: |
John Hill:
--- Quote from: Darren on August 29, 2009, 06:03:07 PM --- I painted my lathe with floor paint........... --- End quote --- Eh what? YOU PAINTED YOUR LATHE? I Turtle Wax mine after every use... :med: |
Darren:
--- Quote from: John Hill on August 29, 2009, 08:49:48 PM --- Eh what? YOU PAINTED YOUR LATHE? --- End quote --- Er yes, isn't yours painted..... :doh: |
Stilldrillin:
--- Quote from: Darren on August 30, 2009, 05:59:49 AM --- --- Quote from: John Hill on August 29, 2009, 08:49:48 PM --- Eh what? YOU PAINTED YOUR LATHE? --- End quote --- Er yes, isn't yours painted..... :doh: --- End quote --- Mine still is....... In a few places! :D |
Navigation |
Message Index |
Next page |
Previous page |