Home Base > Introductions

How's she cuttin lads

(1/3) > >>

twangman:
Hi All,
I followed a link from HMEM some time ago and have been looking in now and again – this is a great site and I see some familiar names -  everybody here seems to be quite civilised (most of the time) so I thought I might as well jump in – don’t have a lot to contribute at the moment cos I’m still learning, (Trying to hit the numbers on my X3 and C4 ( no DROs just using the dials – sometimes it works out just right, but then again, there are times to walk away)). I find the advice, writeups and helpful attitudes from all involved in this hobby to be a major encouragement. I doubt if I could have achieved any headway without these contributions. big thanks to all.

I am based in Dublin, Ireland, and have successfully managed to make (and run) a small Elmers standby engine (snaffled by my 24 year old son when he seen it running – “ I want to show it to me mates”). When it ran first time, I thought the smirk was going to be a permanent fixture on my face.

Hope to get some more involved, and yeah, I know, PICs / PICs s / PICs - later, when I get something worth showing.

Anyway I better get back to paying work - shouldn't be on the internet in the office.

Best Regards

John C.

Brass_Machine:
Welcome to the collective #400  :borg:

Feel free to jump and ask for help. When can help you hit those numbers.

Watcha into?

Eric

CrewCab:
Welcome board John, nice to have you with us  :beer:

CC

spuddevans:
Hi John  :wave: great to have another drone member  :lol:


Pull up a chair and a camera cos  :worthless:


Tim

Stilldrillin:
Hi John.  :wave:

Welcome to the collective.  :thumbup:

I know that smirk, exactly.......  :D

I`ve just machined my first ever flywheel spokes, and made NO mistakes........  :ddb: :ddb: :ddb:

I would not have attempted it, without the great info available on here.  :bow:

Enjoy!

David D

Navigation

[0] Message Index

[#] Next page