The Shop > Our Shop

Changes afoot

<< < (10/10)

bogstandard:
Why for all the trouble milling flats? Just drill a couple of say 1/4" holes in the side, and then make a peg spanner.

Then just to get you out of the crap for the moment, you can use a tommy bar for tightening up, while you make your peg spanner out a bit of hotted up bent bar and a piece of 1/4" silver steel, or whatever size you drilled your holes.


John

CrewCab:
 :bang: I just got back from milling some flats  :dremel: .............. whatever, it's just different ways of cat skinning ain't it .................. a hole would have been easier though  :hammer:

Not to worry, it works fine ...............





CC  :thumbup:

Navigation

[0] Message Index

[*] Previous page