The Shop > Our Shop |
Changes afoot |
<< < (9/10) > >> |
CrewCab:
--- Quote from: John Stevenson on August 09, 2009, 02:20:54 PM ---Yup, the two flats on the collet chuck to hold it whist you wrench the collet nut off, --- End quote --- I thought of that earlier ..... :scratch: ........... and just to make sure I wasn't having another "hacksaw blade" moment I've gone back and looked again ............ no flat's present :bang: It came from Arc Euro, JS can you get them to send me a pair of flats to retro fit :lol: CC |
Darren:
All you need to know..... :thumbup: http://madmodder.net/index.php?topic=1498.0 |
CrewCab:
--- Quote from: Darren on August 09, 2009, 02:36:43 PM ---All you need to know..... :thumbup: --- End quote --- I was sat here thinking, OK I can mill two flats on the chuck, ......... but ............ how do I hold it :scratch: ........... so cheers, :thumbup: whilst I've not yet progressed to 5C stuff, I can stick a round bar in the collet chuck and hold it in the milling vice, I'm not needing half a thou accuracy here after all, half a mil will be fine :smart: I'll be back :dremel: CC |
Darren:
Nah, forget holding by the collet, it's not stable enough......read on in the thread..... :thumbup: |
CrewCab:
--- Quote from: Darren on August 09, 2009, 02:47:59 PM ---.....read on in the thread..... :thumbup: --- End quote --- OK, off to cook tea then walk the dogs, be back in a while :wave: CC |
Navigation |
Message Index |
Next page |
Previous page |