Gallery, Projects and General > Project Logs

Fixing the Beaver Mill Quill Manual Feed Arm

<< < (2/2)

Darren:
Eric,

No probs with orientation as it fits on here with the peg in one of the chosen holes.



David, that did cross my mind but hitting the correct spot from the other side just seemed too great a challenge for me.... :ddb:

Stilldrillin:

--- Quote from: Darren on July 19, 2009, 03:02:53 PM ---David, that did cross my mind but hitting the correct spot from the other side just seemed too great a challenge for me.... :ddb:

--- End quote ---

Darren,

You needed confidence, & a little accurate measurement, only.....  ::)

As we used to say.... "Gerron wi` it! Thar `n engineer, arn`t tha?"   :scratch:

That was nicely sorted mate.....  :clap:

David D

Navigation

[0] Message Index

[*] Previous page