The Breakroom > The Water Cooler
What is wrong?
CrewCab:
--- Quote from: dsquire on August 07, 2009, 01:58:27 PM ---I am willing to bet that you never imagined how much mileage you were going to get out of the bent spike and 2x4.
--- End quote ---
Guys, this image is now an ICON and to be fair is almost the symbol of MadModder :clap: ............. and as such, someone ought to go and check that it is in a place of honour, revered by all who pass by
so who' lives near Bern'd ........................ if there's no takers I'll go if Eric's paying expenses :bugeye:
CC
dsquire:
--- Quote from: CrewCab on August 07, 2009, 02:53:09 PM ---
Guys, this image is now an ICON and to be fair is almost the symbol of MadModder :clap: ............. and as such, someone ought to go and check that it is in a place of honour, revered by all who pass by
so who' lives near Bern'd ........................ if there's no takers I'll go if Eric's paying expenses :bugeye:
CC
--- End quote ---
CrewCab
I never thought of it that way but now that you have mentioned it and the more I think about it, "this image is now an ICON and to be fair is almost the symbol of MadModder". I am quite sure that when bernd sees these posts he will let us know his feelings. :doh:
In the mean time, everyone could email, fax, write, just add a short post here encouraging bernd to do the right thing . :ddb: :ddb:
Cheers :beer:
Don
CrewCab:
--- Quote from: Bernd on July 17, 2009, 10:45:56 AM ---
--- End quote ---
Bernd ............ are we worthy :lol: :smart: :lol:
CC
Bernd:
AW, gee, shucks guys.
I don't know what to say. I guess if it's Ok'd by Eric, it's OK by me.
And all I wanted to do is make a "funny" with that post.
Now I'm going to have to hang that "symbol" on my shop door. Stay tuned pics to follow.
Bernd
websterz:
Summer in Oklahoma + stuffy building = No place to be!
Actually the heat has subsided a bit and I now have no more excuses for not being in the shop, so yesterday I (re)started a couple of projects I have been needing to get done. I made a new baseplate and handwheel for my tailstock, and beefed up the adjusting mechanism. I will post up pics of the finished product and of my tailstock alignment process tomorrow. I also pulled my power feed project out of mothballs and got it about 95% finished. My dad came by with a few large boxes of stuff for my shop the other day, included were several little aluminum project boxes. One of them was a perfect fit for my motor control board, that being the last bit I needed to complete the job. I just have to fab up one more little aluminum bit and attach the controller then that project will be done finally! :D While I'm on the mill I need to get that new Z axis rack installed and find enough scrap lead to cast up a counterweight....here we go again...
:proj:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version