« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: How-to: X2 Mini Mill Torque and Speed increase  (Read 39486 times)

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2911
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
Re: How-to: X2 Mini Mill Torque and Speed increase
« Reply #25 on: July 02, 2009, 02:06:53 AM »
« Last Edit: July 02, 2009, 02:08:52 AM by craynerd »
Logged

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: How-to: X2 Mini Mill Torque and Speed increase
« Reply #26 on: July 02, 2009, 03:15:56 AM »
I `d far rather deal with Arc......

http://www.arceurotrade.co.uk/Catalogue/Bearings/Taper-Roller-Bearings

The width of the bearing is not exact, due to the taper assembly......

David D
« Last Edit: July 02, 2009, 03:17:39 AM by Stilldrillin »
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2911
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
Re: How-to: X2 Mini Mill Torque and Speed increase
« Reply #27 on: July 02, 2009, 03:57:06 AM »
Thanks David! I didn`t know Arc stocked them - thanks a lot for pointing that out.

Chris
Logged

Offline seagar

  • Newbie
  • *
  • Posts: 4
  • Country: au
Re: How-to: X2 Mini Mill Torque and Speed increase
« Reply #28 on: July 13, 2009, 06:57:46 PM »
That site would not open for me.

Ian :(
Logged
measure twice,then check again before cut.Wish I always did.

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: How-to: X2 Mini Mill Torque and Speed increase
« Reply #29 on: July 14, 2009, 03:23:11 AM »
Quote from: seagar on July 13, 2009, 06:57:46 PM
That site would not open for me.

Ian :(

Hi Ian,

Welcome to the collective!

Afraid I can`t help you with your site problems, but someone will be able to, soon, I`m sure.....  :thumbup:

David D
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!
Pages: 1 [2]  All   Go Up
« previous next »