« previous next »
Pages: [1]   Go Down

Author Topic: Printed boots and way covers  (Read 816 times)

Offline BillTodd

  • Hero Member
  • *****
  • Posts: 1165
  • Country: 00
  • Colchester Essex (where the lathes were made)
Printed boots and way covers
« on: May 03, 2025, 10:58:15 AM »
I think this may interest some of you :-)

eature=shared
Logged
Bill

Offline shipto

  • Hero Member
  • *****
  • Posts: 866
  • Country: gb
  • Redditch, UK
Re: Printed boots and way covers
« Reply #1 on: Today at 12:16:17 PM »
Interesting I wonder how it would handle hot swarf though.
Logged
Turns out this life c**p is just one big distraction from death but a good one. For the love of god dont give yourself time to think.
https://myshedblog.wordpress.com/

Offline Muzzerboy

  • Full Member
  • ***
  • Posts: 136
  • Country: gb
    • The Mighty Shiz
Re: Printed boots and way covers
« Reply #2 on: Today at 01:31:56 PM »
Yes, that was my concern, too. OK for sawdust perhaps.
Logged

Offline BillTodd

  • Hero Member
  • *****
  • Posts: 1165
  • Country: 00
  • Colchester Essex (where the lathes were made)
Re: Printed boots and way covers
« Reply #3 on: Today at 04:54:03 PM »
TPU prints ar 230 to 260°C  so it would put up with some abuse  The way covers on my mill are plastic and seem Ok . 
Logged
Bill
Pages: [1]   Go Up
« previous next »