The Craftmans Shop > Radio Control Models

1/16 Scale RC Truck parts

<< < (13/13)

ddmckee54:

--- Quote from: vtsteam on April 13, 2025, 12:21:18 PM ---what would I have to do for fun?  :lol:
--- End quote ---

Steve, you could always do what I do and complain about the quality of the parts you're getting. 

As far as having a better idea of what I talking about, when I modify the pinion shafts and drive shafts I'll take some pictures and things should become a little more clear.

Don

vtsteam:
cool!  :beer:

ddmckee54:
I found that Lesu makes a driveshaft with a 40-45mm range.  I initially had 37mm between the center axle and the rear axle.  If I add 5mm to my center/rear axle spacing that will put me in the middle of the Lesu driveshaft's range.  I did some checking, and the only 3D printed part that I really need to modify to do this is the equalizer beam.

Eventually I will have to determine the hole sizes/locations for the frame rails, but that's a problem for future me.

Don

Navigation

[0] Message Index

[*] Previous page