| Gallery, Projects and General > Gallery |
| Small Punch Tool |
| << < (2/3) > >> |
| BillTodd:
The most accurate machine we had at work was a swiss made Agie (?) it could handle 100um wire . They are bloody expensive to run but capable of astonishing accuracy. The wire edm electrolyte was deionised water from a massive (as big as the edm) filter units. The sparkers , die sinkers, used an oil similar to paraffin, with automatic fire suppression systems (that would occasionally go off without prompting). Yes , the finish is fine but granular, it would need lapping to a cutting edge. |
| philf:
We had an Agiemaspark (not sure how it's spelt) die sinker. As you say it used a paraffin like coolant. It probably went for £100 or so when our toolroom closed! A very useful machine. |
| awemawson:
My Eurospark H425 die sinker is almost identical to the Agiemaspark, in fact many were badge engineered. Here's an ancient thread describing mine: https://www.madmodder.net/index.php/topic,9319.msg103084.html#msg103084 |
| philf:
Andrew - haven't you got a wire eroder as well? |
| awemawson:
Yes Phil, there's a wee little write up about it here on the forum: https://www.madmodder.net/index.php/topic,10085.0.html |
| Navigation |
| Message Index |
| Next page |
| Previous page |