Gallery, Projects and General > Project Logs
Steady for Harrison
vtsteam:
That does look nice! :thumbup: :thumbup: :beer:
shipto:
Progress so far: I have made the brass holders and all thats left to do on them is to bore the end once I have the brass which I forgot to pick up on friday :doh: then work out how I make the adjusters. I am thinking that the end caps might do double duty but not decided yet.
shipto:
Spacers are made and with them in the way shown it will take about 65mm bar. I may need to make some half size spacers but need to get hold of more tube for that as I just about had enough for these.
shipto:
Decided against making the end nuts do double duty and have knocked up 3 7/8UNEF grub screws instead. pic makes them look much worse than they are but I really should have faced them after parting them off but its not like I'm going to give them anyone else.
shipto:
Bit more progress, made some knurled nuts which I had intended to add some slots for a C spanner but I really hope they are not needed because that knurling has come out really well.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version