| Gallery, Projects and General > Project Logs |
| Steady for Harrison |
| << < (3/6) > >> |
| vtsteam:
That does look nice! :thumbup: :thumbup: :beer: |
| shipto:
Progress so far: I have made the brass holders and all thats left to do on them is to bore the end once I have the brass which I forgot to pick up on friday :doh: then work out how I make the adjusters. I am thinking that the end caps might do double duty but not decided yet. |
| shipto:
Spacers are made and with them in the way shown it will take about 65mm bar. I may need to make some half size spacers but need to get hold of more tube for that as I just about had enough for these. |
| shipto:
Decided against making the end nuts do double duty and have knocked up 3 7/8UNEF grub screws instead. pic makes them look much worse than they are but I really should have faced them after parting them off but its not like I'm going to give them anyone else. |
| shipto:
Bit more progress, made some knurled nuts which I had intended to add some slots for a C spanner but I really hope they are not needed because that knurling has come out really well. |
| Navigation |
| Message Index |
| Next page |
| Previous page |