| Gallery, Projects and General > How do I?? |
| Rotary Table Centreing |
| << < (6/6) |
| Stilldrillin:
--- Quote from: Bluechip on July 03, 2009, 05:53:33 AM ---Yup, OK when you've seen it done. Not so obvious if not .. --- End quote --- And when you`ve done it for a while........ You take it for granted, that everyone knows...... ::) --- Quote from: Bluechip on July 03, 2009, 05:53:33 AM ---Works well for me now thanks to Dave SD all is sweetness and light.. till summat else crops up I suppose .. Dave BC --- End quote --- In which case, you know where I am, and me number....... :thumbup: David D |
| kvom:
The DTI method is the most accurate, but can take a bit of time. One fairly quick method is to clamp a bull center in the spindle and adjust the table until the center seats evenly in the RT center hole. This is accurate to a couple of thousands. Another method is to have a plug in the RT hole with a bored hole in the center. Chuck a piece of drill rod that matches the hole and center the table so that the rod can enter that hole. |
| Darren:
Sounds good to me :thumbup: |
| Navigation |
| Message Index |
| Previous page |