Gallery, Projects and General > Project Logs

Reworking of a Denford Mirac CNC lathe.

<< < (2/3) > >>

Spurry:

--- Quote from: awemawson on July 20, 2023, 05:19:29 PM ---.... I do tend to bore people with the minutiae !

--- End quote ---
Au contraire. Your posts are always helpful, informative, and a very useful point of reference.
Please continue in the same vein.  :thumbup:
Pete

john11668:
Used a beefier VFD and now have turret motoring .
In the absence of a Slave board we know to be working, we are adding a dedicated turret board.
We know we have to motor the turret past the required station then back into the lock position and that function is proven.  Board should be fitted this week  then hopefully make some chips.

john11668:

--- Quote from: awemawson on July 20, 2023, 05:19:29 PM ---Its an awful long time ago so memory is hazy, but Id expect that I put all the details in my thread, I do tend to bore people with the minutiae !

--- End quote ---

Cant see anything there Andrew.  Would it be possible for you to check please ??

awemawson:
Remind me what you were asking - the relevant post seems to have been deleted. Bear in mind that I no longer have the machine so can't 'look see'

john11668:
I deleted the irrelevant post , about coming back after dinner

The question was in the prior post
"What is the rated power of the turret motor and what VFD should drive it .
What did you use Andrew?"

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version