Gallery, Projects and General > Project Logs
Fixing the how NOT to make an engine
shoey51:
great job well done John :thumbup: :clap:
would love a video of it running :D
bogstandard:
The vid should be forthcoming in the near future.
I am just tying things up at the moment, getting everything assembled and adjusted.
Bogs
NickG:
Good stuff, can't wait to see the finished make over!
bogstandard:
IT IS FINISHED.
A very quickie tonight
Drilled the cylinders, marked up the covers for drilling and shortened some small headed 8BA bolts to hold them together.
All bolted up, and couldn't resist a bit of bling.
I also knocked up new inlet and exhaust pipes, the original ones were terrible. It just so happened, they brushed against the buffing wheel by themselves.
The control valve casting did the same thing.
Time to make some PTFE cylinder gaskets.
The customer also wanted to know if I could make him an oil and water trap.
Back of the assembled engine.
And now the front.
I finished off the oil and water trap as well.
And just to prove that a scrapper can be brought back to life.
A quickie clean up, and ready for my next project.
Bogs
Bernd:
Bogs,
I have to hand it to you. Another nice job and good runner. It looks way better than when you first started with it.
:bow: :bow: :bow: :ddb: :ddb:
Bernd
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version