Gallery, Projects and General > Oooops!

Spot the mistake


I have been getting used to using my new to me lathe , I had already made a mount so I can use the graver, and I thought next I would make a carriage stop but it needed to be a stop and a mount for the dial gauge well I was chuffed that what I had made was going to do the job until I fitted the dti  :doh: the carriage hits the mount before the full travel of the dti , so a slight modification is needed.

He who's never made a mistake has never made anything !

. . . . it's all a learning exercise  :thumbup:

Could you make an extension for the DI plunger? Might be the easiest fix...

Yes AdeV
That was my thinking as extended pointers are freely available, although I could make one.

 hi a job well dune just make a extension  regards bob


[0] Message Index

Go to full version