| Gallery, Projects and General > The Design Shop |
| Small Press to fit in a Tiny shop? |
| << < (4/6) > >> |
| vtsteam:
The Atlas P10 press apart: |
| awemawson:
I'm not seeing your pictures Steve in Chrome (ok on my iPad though) |
| vtsteam:
Yes, sorry Andrew, it's because the pics are served on my http site instead of https, and Google is censoring the web. |
| Joules:
WeldingRod, that is a nice setup, much better than my angle iron and studding. I should have a look at what plate I have stashed. |
| vtsteam:
Yes, sorry welding rod, forgot to say, nice work! :clap: I spent a couple hours today sanding and wire-brushing the Atlas press. I also got a coat of primer on it, but it's starting to look like rain, so cover paint may have to wait. Oh, I also cut an 18" piece of rod for a handle. I don't have any tool steel that length, so I hope it will be tough enough. If not, I'll replace it down the road. Camera has created an exaggerated upper bearer bend in the pic below -- it's actually only about 1/16" over 21" and it doesn't bend inboard at all. |
| Navigation |
| Message Index |
| Next page |
| Previous page |