« previous next »
Pages: [1]   Go Down

Author Topic: Collet identity Question  (Read 6673 times)

Offline vintageandclassicrepairs

  • Full Member
  • ***
  • Posts: 219
Collet identity Question
« on: May 10, 2022, 06:18:10 PM »
Hi All,
Yet another gifted items was this collet set, from 1/4in. to 5/8in. (missing 1/2in. one)
The draw bolt thread is 5/8in. UNF and overall length is about 2 3/16in.
Also included was this 5C collet
I do not have any use for these as my mill uses DA180 collets so they are available

John
Logged

Offline Kjelle

  • Full Member
  • ***
  • Posts: 178
  • Country: se
Re: Collet identity Question
« Reply #1 on: May 11, 2022, 05:23:50 AM »
I haven't the slightest idea, but in my bookmarks, I have this page; http://www.tools-n-gizmos.com/specs.html There are more than these out there of course, but short of going into Practical machinist, and asking there, it's a good starting point.

Kjelle
Logged

Offline chipenter

  • Hero Member
  • *****
  • Posts: 909
  • Country: gb
Re: Collet identity Question
« Reply #2 on: May 11, 2022, 11:07:41 AM »
3C ,4C and 5C have external threads as well as internal .
Logged
Jeff

Offline mc

  • Full Member
  • ***
  • Posts: 108
Re: Collet identity Question
« Reply #3 on: May 11, 2022, 12:08:51 PM »
They look homemade.
Possibly 5C collets (without external thread) for a milling machine?
Logged
Pages: [1]   Go Up
« previous next »