The Shop > Our Shop
Electricity getting very expensive in the Workshop
<< < (7/12) > >>
awemawson:
The motor is a DC Mawdsley one . It has a 1.5 HP cooling fan blowing into it all the time.

Current consumption of other devices seems sensible - certainly not out by a factor of ten
vtsteam:
26.97 KW = 36 Hp.  :jaw:

It can't really take that much to spin a ground shaft in precision bearings.
awemawson:
OK it's spinning the gear train as well but I agree to being surprised.

Does a DC motor actually vary it's consumption much? With AC drive you have the motor reactance which goes down on load hence drawing more amps - what is the case in a DC drive?



vtsteam:
Maybe Ebay purchases didn't pan out this time? Not that I don't make them myself......
awemawson:

--- Quote from: vtsteam on May 13, 2022, 11:41:15 AM ---26.97 KW = 36 Hp.  :jaw:

It can't really take that much to spin a ground shaft in precision bearings.

--- End quote ---

It's rated at 26.5 HP 400 volts and  34 to 75 amps DC depending on speed with 170 volts on the field coils whose current is separately controlled  - plate below
Navigation
Message Index
Next page
Previous page

Go to full version