The Craftmans Shop > New from Old

Re-Birth of an Oil Dispenser

<< < (4/4)

awemawson:
I don't think so Phil. The majority is newish pvc of the nylon reinforced variety, leading to a small tap and finished with about 4" of flexible moulded rubber to put in the actual oil filling hole of whatever you are filling. The whole hose assembly has been repeatedly flushed and also blown out with an airline.

If things persist I'll remove that final moulded rubber bit and try again but I think that's in the straw clutching arena !

awemawson:
Prompted by Phil's last post I've just gone over to the workshop and fitted a clean filter paper and pumped a further 2.5 litres 'round the loop' and I'm glad to report no particles.

I did remove the flexy end of the hose and inspect it but it was clean as a whistle.

Picture of the hose end assembly for clarity:

Navigation

[0] Message Index

[*] Previous page