Gallery, Projects and General > How do I??
Peening tips?
Mike K:
Another question...
The elbow hole of that harm holds a pivot piece that the leadscrew fastens to...It'll turn as the clamp opens and closes. I have a rod of bearing bronze that I was thinking of using for it. Will that peen well? Or will it distort too much and leave me with a bad pivot? It's part #7 in the diagram.
chipenter:
I made my pivot pins longer and when peening kept turning the pivot until it felt right .
efrench:
#7 and #4 are not peened on the real thing.
p.s. One of the #3's is not peened.
Mike K:
--- Quote from: efrench on October 29, 2021, 05:31:41 PM ---#7 and #4 are not peened on the real thing.
p.s. One of the #3's is not peened.
--- End quote ---
Now that I think about it, it makes sense...the pivots don't need to be peened as the plates are already bound by the other pins that *are* peened. And that explains why there is a #3 so close to that pivot. Thanks.
Mike K:
--- Quote from: chipenter on October 29, 2021, 03:28:47 AM ---I made my pivot pins longer and when peening kept turning the pivot until it felt right .
--- End quote ---
I may do this if the 16 gauge plate winds up being too flexible. Thanks.
Navigation
[0] Message Index
[*] Previous page
Go to full version