Gallery, Projects and General > Project Logs

3d printer - Leapfrog creatr conversion

<< < (12/12)

I may be premature but, this is as done as I can get it, until the touch sensor arrives.

A sleek Biqu microprobe arrived promising +/- 3um accuracy ....

While measuring the logic output, I found it  has a linear range of about 200um thus making it entirely reliant on the logic threshold of the I/O port -   :bugeye:

I cannot seem to get Marlin to use the probe as a Homing device , which is what i bought it for , as i don't really need to level the bed every print and only want to be able to change surfaces (which will vary in height) .


[0] Message Index

[*] Previous page

Go to full version