Hi,
It is Multicomp-pro PLA sliced in cura with a 0.3 layer ,(0.4 nozzle) . I'm new to Cura but having failed to stop Prusaslicer causing blob on insert after retract I swapped . Cura's default seem better chosen. except...
I've just had to cancel a print 2 hours in because of missing supports.
I also need to get myself a proper build plate. I have a PEI sheet stuck to a steel plate that bubble up and pings the part off after a while, A creality style plastic sheet to which PLA sticks like s*** to a blanket, but bulges in the middle if I heat just the middle plate , and a painted steel plate that seems OK but just doesn't have quite enough 'stick' for deeper parts.
I'm looking for a custom PEI spring plate supplier (the one I knew in the UK has folded) 310x350 is not standard . I can get 350x350 but I'd need to cut it and I don't think my guillotine will cut a spring tempered sheet well.