Gallery, Projects and General > Project Logs
3d printer - Leapfrog creatr conversion
PekkaNF:
--- Quote from: BillTodd on November 01, 2021, 11:18:08 AM ---
...but with a little kinetic adjustment , it does work.
--- End quote ---
Care to explain? Something like percussive maintenance comes into my mind, but probably not....
BillTodd:
Similar process , one fixes something that once worked but now doesn't the other get something to work that never did.
tap, tap twist ... tap tap twist , HAMMER HAMMER oops that sort of things :-)
PekkaNF:
Thank you. All clear now. I have done my share of tap-tap-tapiti-tap and tweak-tweak-blimey adjustments myself....sometimes even in system that mechanical stickiness, analog measurement (and sometimes even control loop) and digital/SW controls....sometimes it is hard to know even where to start.
Hope this gets sorted with relative ease.
BillTodd:
Finally got around to wiring and the extruder mount.
The connector is a 41612/3 but I didn't have one in stock (and Farnell wanted £18 quid for one or £250 for a 100) so had to make one from two bits of a full size 96way one .
There's wiring for dual extruders, 3 fans and a few spares for whatever comes up
awemawson:
Neat :thumbup:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version