Author Topic: Kant-Twist style clamp with 16 gauge sheet  (Read 270 times)

Offline Mike K

  • Jr. Member
  • **
  • Posts: 98
  • Country: us
Kant-Twist style clamp with 16 gauge sheet
« on: October 13, 2021, 05:52:53 PM »
Or maybe Kan-Twist.  We'll see.

I marked out some sheet yesterday and cut blanks today.  For two clamps.  Going to drill, pin together, and shape to final size as a stack for each leg.  Probably tomorrow.  Just waiting for the super glue to dry.  At some point this stuff got really good (used to be terrible), but now takes 24 hours to fully cure.  I never noticed the 24 hours part until I searched today...it didn't even say it on the package.

Anyway, I'm making small size clamps.  The PDF I have contains an example spec'd drawing that's about 5" across the fully opened height.  And I went with 2/3rds of that size.

I have no blocks of copper ($$) so I guess it'll be steel or element number 13 for the jaw pads.  And the screw will probably be zinc plated if i can find it easily enough.

Offline Mike K

  • Jr. Member
  • **
  • Posts: 98
  • Country: us
Re: Kant-Twist style clamp with 16 gauge sheet
« Reply #1 on: October 16, 2021, 11:09:50 PM »
Irony: I had to buy more clamps so I could make these other clamps.  I rough cut the leg stacks this evening.  Have to sand to the scratched lines, if I can still find them.  And drill the holes.

 

Offline Mike K

  • Jr. Member
  • **
  • Posts: 98
  • Country: us
Re: Kant-Twist style clamp with 16 gauge sheet
« Reply #2 on: October 19, 2021, 05:15:34 PM »
Drilled and reamed the holes.  Brought them to final shape on my 1x30 belt sander.  Separated them and deburred all edges and THEN I realized that I forgot to drill one of the holes in the large arm.  Fortunately I didn't remove the bluing and can still see the location (not really visible in the photo; lower left corner).