Gallery, Projects and General > The Design Shop
box tool with parting.
philf:
--- Quote from: shipto on August 21, 2021, 03:42:15 AM ---I guess a pin in a vertical slot would make sure it didn't get stuck forward, good shout. Do you have any pictures of the one you made BTW?
--- End quote ---
Here are a few pics:
In the first pic the larger grub screw is to adjust the cutting edge to dead-on centre height.
A parting tool would have to be directly opposite the cutting edge of the diameter tool so would have to mount to the 6mm plate which carries the guide bushes.
I do have a CAD drawing somewhere.
Cheers.
Phil.
shipto:
Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea.
philf:
--- Quote from: shipto on August 21, 2021, 03:03:25 PM ---Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea.
--- End quote ---
The 'chamfer' is an optical illusion - it's quite sharp with perhaps a 0.1mm stoned radius.
shipto:
--- Quote from: philf on August 21, 2021, 03:24:21 PM ---
--- Quote from: shipto on August 21, 2021, 03:03:25 PM ---Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea.
--- End quote ---
The 'chamfer' is an optical illusion - it's quite sharp with perhaps a 0.1mm stoned radius.
--- End quote ---
Fair enough :)
Navigation
[0] Message Index
[*] Previous page
Go to full version