| Gallery, Projects and General > The Design Shop |
| box tool with parting. |
| << < (2/2) |
| philf:
--- Quote from: shipto on August 21, 2021, 03:42:15 AM ---I guess a pin in a vertical slot would make sure it didn't get stuck forward, good shout. Do you have any pictures of the one you made BTW? --- End quote --- Here are a few pics: In the first pic the larger grub screw is to adjust the cutting edge to dead-on centre height. A parting tool would have to be directly opposite the cutting edge of the diameter tool so would have to mount to the 6mm plate which carries the guide bushes. I do have a CAD drawing somewhere. Cheers. Phil. |
| shipto:
Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea. |
| philf:
--- Quote from: shipto on August 21, 2021, 03:03:25 PM ---Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea. --- End quote --- The 'chamfer' is an optical illusion - it's quite sharp with perhaps a 0.1mm stoned radius. |
| shipto:
--- Quote from: philf on August 21, 2021, 03:24:21 PM --- --- Quote from: shipto on August 21, 2021, 03:03:25 PM ---Exellent, I noticed the chamfer on the cutting tool that would be for countersunk bolts? I am still thinking over some of the details for mine but have made a start so will start a thread after I have had my tea. --- End quote --- The 'chamfer' is an optical illusion - it's quite sharp with perhaps a 0.1mm stoned radius. --- End quote --- Fair enough :) |
| Navigation |
| Message Index |
| Previous page |