Gallery, Projects and General > How do I?? |
Tailstock Turret toolholder ? |
(1/2) > >> |
paulmo101:
Hi Just wondering if anyone uses a tailstock turret tool holder ? I`m looking at the arc euro stuff and I think it would be useful when doing ops such as drill and taping as I would usually use a centre drill then a taping drill then maybe a csk bit to give a lead in and then a taping guide along with the tap. This would be 4 tool changes and if doing say 5 or so of the same item the time adds up. Just looking for any thoughts on the turrets - good, bad or otherwise. Also anyone know of a supplier for a Jacobs taper 2 to straight shank - around 12mm would be great ? I know I can make one failing all else. Thanks for reading |
Henning:
I have a tailstock turret which i have used on a few occasions. I’ve slowly come to the conclusion that it has to be quite the repeating job before I set it up, but I’m always glad to have it when those jobs do come around. Mine is bought several years ago from Arc. The locking mechanism on mine leaves a little to be desired but it does work. In a flash of inspiration I bought quite a few of the blank end arbors for it. That was a good decision as it means I can make my tool setups more rigid. |
paulmo101:
Thanks for the reply |
awemawson:
I have an MT3 one somewhere that on occasion has been handy - centre drill - tapping drill - tap sort of thing but in all honesty I'd be pushed to locate it' If I do I'll pop a picture up |
paulmo101:
Thanks for the replies |
Navigation |
Message Index |
Next page |