The Shop > Tools

Sheet metal bending tool - not brake

(1/2) > >>

picclock:
Saw this on youtube :

&t=1s

Has anyone made something similar ? 

It appears useful for very long bends and allows multiple bends and returns. Only minor snag I can see is it has to follow the edge of the sheet.

Thought I might crib the idea and make a DIY version, as I have some bends to make just over a metre long.

Any thoughts much appreciated.

Best Regards

picclock

BillTodd:
Probably fine for bending thin zink for roofing etc. But those long bending-axles are not going to provide much clamping force , which will result in some large radius bend and probably variable radius too.

Maybe a lot of work to make one for little return .

picclock:
This is the simpler version. It would very useful for multiple edge bends, which are all but impossible with a brake.
I would only make it good for 4" depth or so as I doubt I would need more.
Best Regards
picclock

BillTodd:
Yes thats probably simple enough to build and test .

picclock:
Different video with quite good results, skip 6-8 mins unless you want to  learn how to paint.
Same idea but only two bending rollers. 
&t=95s

picclock

Navigation

[0] Message Index

[#] Next page