Gallery, Projects and General > Member Videos
Schaublin 125-CNC retrofit to LinuxCNC and Mesa cards.
BillTodd:
Tip for pulling reluctant dowlpins , use an er collet chuck to grab the pin and threaded rod as a diy slide hammer.
awemawson:
And when you replace them always put one in with a female extractor thread - dead easy to do, and the next bloke to come along will thank you !
(Had that issue with the powered tooling gear boxes on my CNC lathe, making a female threaded dowel was the work of minutes on the lathe.)
RotarySMP:
Good points. I'll check if these are hardened, and if not I could drill and tap the end.
RotarySMP:
RotarySMP:
Little more progress...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version