Gallery, Projects and General > Project Logs
Worden grinder
John Rudd:
Here's a photo of some of the parts of my Worden I've been building.......the troublesome plate that needed some drawing help... :lol:
On the left the end mill sharpening jig, the right, the slit saw jig.
John Rudd:
I deviated slightly from the plans.....as you do.
On the slit saw jig, it calls for the hole in the main block to be 11/32" to match the bush on the main body.
I decided to make a bush slightly smaller, so all I had to do was unscrew the end mill block with its threaded bush and screw on the slit saw assy.
After completion, I though about what I'd done....not necessarily a good idea....wear on the feed screw?
vtsteam:
Great to see this in the flesh, John! :dremel: :thumbup:
John Rudd:
I'll take some snaps of the rest of the grinder once the rain stops!( I'll get wet going to the garage... :doh: 😂🌂🌂🌧🌧☔️☔️ )
Spurry:
--- Quote from: John Rudd on January 19, 2021, 11:48:25 AM ---I'll take some snaps of the rest of the grinder once the rain stops!( I'll get wet going to the garage... :doh: 😂🌂🌂🌧🌧☔️☔️ )
--- End quote ---
Hope you don't need a snorkel....
Navigation
[0] Message Index
[#] Next page
Go to full version