| Gallery, Projects and General > How do I?? |
| Rotary Table Chuck Adaptor Plate |
| << < (4/5) > >> |
| sbwhart:
Ok finished off the small hand wheels I started last night. Drilled 6*3mm holes 25mm deep enough to make three or four wheels Took the chuck off the RT with the job still in place and remounted it on the lathe. Trepanned a shallow recess in the face of the wheel. Rounded the corners off with a file and gave it a quick polish with emery cloth. Drilled down the midle 2mm dia Then parted it off in two stages:- adavanced for a 3mm wide wheel, took the tool down so that the through holes were cleaned up, adavanced tool 1.5mm then parted off this formed a nice boss on the back of the wheel, didn't get a good pic of this. Thats it job done far easyer on the pocket than buying casting Have fun :D :D Stew |
| DavesWimshurst:
Stew, Those hand wheels look great. Well done. :beer: Just don't mistake them for decorations for chocolate cake! :lol: Dave |
| Stilldrillin:
VERY nicely done Stew! :clap: :clap: David D |
| Darren:
Very nice Stew.....I wish you guys would stop using the RT's.....I've got enough to do at the mo without you lot showing off all the time... :lol: :lol: :lol: Very nice... :clap: |
| DeereGuy:
Stew looks like you accomplished the task you set out to do and it works for...nice job! |
| Navigation |
| Message Index |
| Next page |
| Previous page |