Author Topic: kankarrio  (Read 4532 times)

Offline kankarrio

  • Jr. Member
  • **
  • Posts: 8
kankarrio
« on: October 16, 2020, 02:26:33 PM »
Greetings to all from Spain

I apologize for my English, I use a translator

searching the web http://pandora-cnc.eu/
 cnc system information ddcsv has directed me to this forum



I feel that because of the language I will not be very active, I have been looking to resolve doubts about the ddcsv

In Spain I am very active in the http://forometalaficion.com/foro/

thanks to everyone

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5504
  • Country: us
Re: kankarrio
« Reply #1 on: October 16, 2020, 02:43:02 PM »
Hi and welcome!

No apologies needed. You aren't the first to use a translator to join discussions. We will make do!

Eric
Science is fun.

We're all mad here. I'm mad. You're mad.

Offline ddmckee54

  • Sr. Member
  • ****
  • Posts: 306
  • Country: us
Re: kankarrio
« Reply #2 on: October 16, 2020, 05:20:00 PM »
kankarrio:

Welcome to the forum.  Your English would not be any worse than my Spanish, because I would have to use a translator just like you.

Earlier this year I bought a DDCSV for use in a CNC router that I am building.  I cannot tell you how it is working because I have not been working on that project for a while, I really need to get back to work on it. 

There is a thread on this forum about the DDCSV that spans several years, and after talking with them I have high hopes for my project.  Let us know how yours works out.

Don
Too many irons, not enough fire.

Offline WeldingRod

  • Sr. Member
  • ****
  • Posts: 400
Re: kankarrio
« Reply #3 on: October 17, 2020, 12:43:14 PM »
Welcome aboard!
My DDCSV runs my cnc router successfully.  I really need to update the firmware; there is mistake in one direction of circular interpolation.
I do my gcode processing with short segments rather than true curves.

Sent from my SM-G892A using Tapatalk


Offline kankarrio

  • Jr. Member
  • **
  • Posts: 8
Re: kankarrio
« Reply #4 on: October 25, 2020, 12:48:48 PM »
thanks to everyone

Weldingrod I had the same problem in my ddcsv2.1 and I changed a parameter in the aspire and it was solved