Gallery, Projects and General > How do I??

Low Profile Transfer Plate

<< < (3/3)

sbwhart:
Hi John

I've ordered a plain back plate and a M2 mandrel with a soft front (40mm dia), what I was thinking of doing was to turn a shoulder on the mandrel a good fit on the plate, glue and screw it in place, then turn a boss on the plate to fit the chuck, the plate should stand proud enough to get at the screws to tighten the chuck down, the mandrel will have a M2 draw bar to lock it all up.

Hope you understood this I'll post a crap O cad later when I've had me tea.

Cheers

Stew

DeereGuy:
Klank, nice right up!  Thanks!

John Stevenson:
Thought I'd seen it before. :ddb:

http://bbs.homeshopmachinist.net/showthread.php?t=20653

September 21st 2006

Navigation

[0] Message Index

[*] Previous page