| Gallery, Projects and General > How do I?? |
| Low Profile Transfer Plate |
| << < (3/3) |
| sbwhart:
Hi John I've ordered a plain back plate and a M2 mandrel with a soft front (40mm dia), what I was thinking of doing was to turn a shoulder on the mandrel a good fit on the plate, glue and screw it in place, then turn a boss on the plate to fit the chuck, the plate should stand proud enough to get at the screws to tighten the chuck down, the mandrel will have a M2 draw bar to lock it all up. Hope you understood this I'll post a crap O cad later when I've had me tea. Cheers Stew |
| DeereGuy:
Klank, nice right up! Thanks! |
| John Stevenson:
Thought I'd seen it before. :ddb: http://bbs.homeshopmachinist.net/showthread.php?t=20653 September 21st 2006 |
| Navigation |
| Message Index |
| Previous page |