Gallery, Projects and General > Project Logs
Oxy-Acetylene Storage Cage
awemawson:
This morning I welded on the hold down plates that will be used to bolt the cage to the concrete, and also a door 'close plate' to stop the hinges over traveling.
Then I modified the hinges so that they can be bolted on rather than welded, and then swung the doors. I've welded a cap on the hing pins to stop them being easily knocked out, and eventually will 'slight' the bolts in the Cromwellian sense to prevent them being unscrewed.
After lunch I put on the worst coat of paint I can remember spraying - JCB yellow - to be fair it was blowing a gale but it certainly looks grotty. Most will be covered by the galvanised cladding thank goodness.
mattinker:
Andrew,
A roller work better than a spray gun for this sort of thing!
Cheers, Matthew
hermetic:
When I had a set of bottles, I mounted them in the compressor shed chained to the wall, well ventilated, with the regulators on and the pipes led through the wall and coiled up on a wall bracket. Worked well for me for many years, but I was gifted some long pipes with the kit when I bought it!
Phil
Phil I need to roll the trolleys from place to place 'to the job' - work isn't always at the bench
awemawson:
--- Quote from: mattinker on March 30, 2020, 12:00:09 PM ---Andrew,
A roller work better than a spray gun for this sort of thing!
Cheers, Matthew
--- End quote ---
No doubt I'll be touching it up with a roller Matthew when I've rubbed down the numerous runs, but rolling mesh is no fun !
charadam:
Andrew,
Great work as always.
I'm wondering what it costs to have bulk tanks outside with the gases piped into the building - or do you need the mobility of bottles on a trolley?
Charles
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version